The inner attach picture shows all the dry wall screws in the hull. These have p clips attached. These will be the lower cable tie skirt attach points. They were all trimmed so as no to have a bunch of spikes in the hull.
The inside where the trimming happened was sprayed with spray rubber to seal the hull. Also notice the air feed holes are glassed all the way through.
The side and rear decks are glued together with the hot glue gun and then glued in place. No great skill required here the parts go together very nicely.
The inner attach picture shows all the dry wall screws in the hull. These have p clips attached. These will be the lower cable tie skirt attach points. They were all trimmed so as no to have a bunch of spikes in the hull.
The inside where the trimming happened was sprayed with spray rubber to seal the hull. Also notice the air feed holes are glassed all the way through.
The side and rear decks are glued together with the hot glue gun and then glued in place. No great skill required here the parts go together very nicely.
Originally posted to the Australian Hovercraft Association forum
Share this:
Like this:
Jeremy Ludlow